EmergencyShelter.com ← Home

If you have to go

How to Use a Map and Compass: Land Navigation Basics

Phones lose signal, batteries die and navigation apps happily route you toward a closed road. A paper map and a compass do not. Here is how to read one, set the other and actually find your way.

November 17, 2026 / 8 min read

N 057° C / CONTOURS A / START B / TARGET D / TRAVELARROW E / DIAL F / RED IN THE SHED FIG. 01 / TAKE A BEARING, THEN WALK IT
Fig. 01 / Map oriented, bearing set, needle boxed

To use a map and compass, lay the compass edge along a line from where you are to where you want to go, turn the dial until its lines match the map's north lines, correct for declination, then turn your body until the needle sits inside the orienting arrow. Walk where the direction-of-travel arrow points, from landmark to landmark.

That is the whole skill in one paragraph. The rest is practice, and practice is what most people skip. A compass in the bottom of a bag is a comfort, not a tool, until you have used it on a real trail with a real map and found the place you were aiming for.

For anyone planning to leave home on foot or by back roads in an emergency, this is worth an afternoon. Cell networks fail in exactly the conditions that send people onto unfamiliar roads, and a paper map does not need a signal, a charge or a server.

What kind of map is best for land navigation?

A topographic map is best for land navigation because it shows the shape of the ground with contour lines, along with streams, trails, buildings and power lines. In the United States, the USGS 1:24,000 series, often called 7.5-minute quads, gives enough detail for travel on foot. Road maps leave out the terrain you need.

Buy or print the maps that cover your home, your routes out and your destination. Check the date in the margin; trails, roads and clearings change over the years. Keep them dry in a waterproof sleeve.

How to read contour lines

  • Each contour line joins points of the same elevation. The contour interval in the margin tells you the height between lines.
  • Lines close together mean steep ground. Lines far apart mean gentle or flat ground.
  • A set of closed rings is a hilltop. Rings with small tick marks pointing inward are a depression.
  • Contour lines bend into a V where they cross a valley or stream. The point of the V faces uphill.

What kind of compass do you need?

For map work, you need a baseplate compass, also called an orienteering compass. It has a clear rectangular base with a direction-of-travel arrow, a rotating dial marked in degrees, orienting lines inside the dial and a magnetic needle. A model with adjustable declination saves you from doing arithmetic in the field.

Learn the parts by name, because every technique below refers to them:

  • Direction-of-travel arrow: the arrow on the baseplate. It points where you walk.
  • Dial (bezel): the rotating ring marked from 0 to 360 degrees.
  • Orienting arrow and lines: printed inside the dial. You line these up with the map's north lines.
  • Magnetic needle: the red end points to magnetic north.

Keep the compass away from steel, car bodies, phones and power lines when you read it. All of them can pull the needle.

What is magnetic declination and how do you correct for it?

Magnetic declination is the angle between true north, which maps use, and magnetic north, where a compass needle points. It differs from place to place and drifts slowly over the years. Correct for it by setting the adjustment on your compass, or by adding or subtracting the declination each time you move a bearing between map and ground.

Your map's margin shows the declination for the year it was printed. For a current value, NOAA publishes a free online declination calculator. A rule of geometry shows why this matters: every degree of error pushes you roughly 90 feet sideways for each mile you walk, so a ten-degree mistake can put you well off target in a few miles.

If your compass does not adjust, use the old memory aid when converting a map bearing to a compass bearing: east is least, west is best. Subtract an easterly declination; add a westerly one. Reverse it when you go from compass to map.

How do you take a bearing from a map?

To take a bearing from a map, place the compass edge so it connects your position to your destination, with the direction-of-travel arrow pointing toward the destination. Turn the dial until the orienting lines run parallel to the map's north lines, with north up. Read the number at the index line, then correct it for declination.

  1. Lay the compass on the map, edge from you to your target.
  2. Rotate the dial so the orienting lines match the map's north-south grid, orienting arrow pointing to map north.
  3. Read the bearing at the index line and apply declination if your compass does not do it for you.
  4. Lift the compass and hold it flat at your waist, travel arrow pointing straight ahead.
  5. Turn your whole body until the red end of the needle sits inside the orienting arrow. Many instructors call this "putting red in the shed."
  6. Look along the travel arrow, pick a tree or rock on that line, walk to it, and repeat.

Walking to a series of close landmarks keeps you on line far better than staring at the compass while you walk.

How do you find your location with a compass?

Find your location with a compass by triangulation. Identify two or three landmarks you can see on the ground and on the map, take a bearing to each, convert each to a back bearing and draw those lines on the map from the landmarks. Where the lines cross, or form a small triangle, is your approximate position.

Choose landmarks spread widely apart, ideally close to ninety degrees from each other. Two peaks nearly in line give a long, thin crossing that tells you very little. If you are on a known trail, river or ridge, one bearing is often enough: where that line crosses the feature is where you stand.

Lost and in danger? Stop moving, stay warm and call 911 if you have any signal. Three blasts on a whistle is a widely recognized call for help. A map and compass are for staying found, not for pushing on through darkness or bad weather.

How do you measure distance on foot without GPS?

Measure distance on foot without GPS by pace counting. Walk a measured 100 meters several times, counting every time your left foot lands, and average the results. That number is your pace count. On the move, count paces and mark each 100 meters with a knot, a pebble moved between pockets or a set of sliding beads.

Your count rises uphill, in mud, in snow, in the dark and under a heavy pack, so measure it again in those conditions. Paired with a bearing, a pace count tells you both direction and distance, which is all you need to know where you are on the map.

How do experienced navigators use terrain instead of the compass?

Experienced navigators use terrain association: they read the land and match it to the map, using the compass only to confirm. They follow handrails such as streams, ridges and power lines, set a catching feature beyond the target to signal an overshoot and aim off deliberately to one side so they know which way to turn.

  • Handrails: long features that run in your direction. Follow them instead of a strict bearing.
  • Catching features: a road, river or clearing just past your target. If you reach it, you have gone too far.
  • Aiming off: to reach a bridge on a river, aim a little upstream. When you hit the river, you know to turn downstream.

How do you practice map and compass skills?

Practice map and compass skills in a local park, state forest or on a familiar trail before you ever need them. Start by orienting the map and naming features you can see, then walk short bearings between known points, measure your pace count and finally try triangulating your position. Navigation is a perishable skill, so repeat it each season.

Make it a family outing. Kids are good at spotting landmarks and keeping the pace count. Add a map and compass to your bug out bag, keep a road atlas in the car and mark your routes to the places you would go, such as the ones in our guide to choosing a bug-out location.

Most days you will never need any of this. But the skill weighs nothing once you have it, and on the day the screen goes blank, it turns a strange road into a route you can trust and a long walk into a way home.

Frequently asked questions

Can you use a phone compass instead of a real compass?

A phone compass is a useful backup, but not a replacement. It depends on battery and calibration, can be thrown off by a magnetic case or nearby metal, and is hard to use on a paper map. A baseplate compass works in rain and cold without power. Carry both, and learn the real one first.

Where can you get topographic maps for free?

The U.S. Geological Survey offers its topographic maps as free downloads through its online map store and viewer, and you can print them at home or at a print shop. State park and forest offices often have free trail maps as well. Print on heavy paper and keep the maps in a waterproof sleeve.

What does "putting red in the shed" mean?

"Putting red in the shed" is a memory aid for following a bearing. The red is the north end of the compass needle, and the shed is the outlined orienting arrow on the dial. Turn your body, not the dial, until the needle sits inside that arrow. The direction-of-travel arrow then points the way to walk.

How accurate is pace counting?

Pace counting is accurate enough to tell you when you are close to a target, especially over short legs, if you measured your count honestly and adjust for hills, mud and fatigue. Errors grow over long distances, so break a route into short legs that end at a landmark you can recognize, then start counting again.

At a glance

Map and compass

  • Use a topographic map, not a road map; check its date
  • Close contour lines mean steep ground, wide lines mean flat
  • A baseplate compass with adjustable declination is the one to buy
  • Correct for declination: east is least, west is best
  • Take the bearing on the map, then put red in the shed
  • Walk from landmark to landmark along the bearing
  • Triangulate with two or three well-spread landmarks
  • Know your pace count per 100 meters
  • Practice in a park each season before you need it
Find your shelter score More guides